The OnHandFlow event occurs when other application changes flow control parameters of the sniffed serial port.

 OnHandFlow(
  LONG ControlHandShake, //  Handshake control parameter
  LONG FlowReplace, // Flow control parameter
  LONG XOnLimit, // Flow control parameter
  LONG XOffLimit // Flow control parameter
);


Parameters
ControlHandShake     [In] ControlHandShake is a set of flags that defines the modem lines that are used for flow control. Can be combination of the following flags:

ValueMeaningHex
 SERIAL_DTR_CONTROL Enables the DTR line when the device is open and leaves it on.
 0x01
 SERIAL_DTR_HANDSHAKE Use the modem signal DTR for input flow control. For the real serial port the DTR line is cleared by the controller if the received buffer reaches the programmed high water mark.
See also description of XonLimit and XoffLimit.
 0x02
 SERIAL_CTS_HANDSHAKE Use the modem signal CTS, DCD or DSR respectively for output flow control. For the real serial port if the corresponding modem line(s) found as cleared, the controller will hold data transmission.
 0x08
 SERIAL_DCD_HANDSHAKE
 0x20
 SERIAL_DSR_HANDSHAKE
 0x10
 SERIAL_DSR_SENSITIVITY Ignore any character arriving when the DSR line is not set.
 0x40
 SERIAL_ERROR_ABORT If there exists an error condition the driver stops reading and writing from or to this port.
 0x80000000

 

FlowReplace

[In] FlowReplace is a set of flags defining flow control stuff. Can be combination of the following flags:


ValueMeaningHex
 SERIAL_AUTO_TRANSMIT Use the XON/XOFF protocol based flow control for output.
 0x01
 SERIAL_AUTO_RECEIVE Use the XON/XOFF protocol based flow control for input.
 0x02
 SERIAL_ERROR_CHAR If set, the ErrorChar is placed in the stream of received characters on error
conditions like buffer overflow, frame errors and so on.
 0x04
 SERIAL_NULL_STRIPPING If set, the reception of a NULL character is ignored.
 0x08
 SERIAL_BREAK_CHAR If set, the BreakChar is placed in the stream of received characters when a break condition was detected.
 0x10
 SERIAL_RTS_CONTROL Enables the RTS line when the device is open and leaves it on.
 0x40
 SERIAL_RTS_HANDSHAKE Use the modem signal RTS for input flow control.
0x80 

XOnLimit 

[In] Minimum number of bytes allowed in the input buffer before flow control is activated to inhibit the sender.

XOffLimit

[In] Maximum number of bytes allowed in the input buffer before flow control is activated to allow transmission by the sender.